Twiddler

User Tools

Site Tools

Trace:
t4_datalogger

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
t4_datalogger [2024/06/04 18:20] – tonyt4_datalogger [2024/07/09 17:31] (current) – lalaine
Line 1: Line 1:
-===== Untethered Re-Cording Mode =====+===== Untethered Re-Chording Mode =====
  
 //**Feature still under development**// //**Feature still under development**//
  
-Untethered Re-Cording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run hostless and will record every HID code to an on-board data file. It acts as a Datalogger.+Untethered Re-Chording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run hostless and will record every HID code to an on-board data file. It acts as a Datalogger.
  
-When recording, the Twiddler saves the keystrokes in a .log file on the Twiddler.  The naming corresponds to the config file you were using at the time.  Example:  You are using 1.cfg and start Untethered Mode.  The datafile will be 1.log.  +Use tuner to enable this mode and assign its functions to your preferred key chord. 
 + 
 +When recording, the Twiddler saves the keystrokes, in HID format, in a .log file on the Twiddler.  The naming corresponds to the config file you were using at the time.  Example:  You are using 1.cfg and start Untethered Mode.  The datafile will be 1.log.  
  
 To retrieve the recorded data:  To retrieve the recorded data: 
Line 17: Line 19:
 There are utilities available, like [[https://github.com/CoohLand/Trout|Trout]] for Linux, that will directly read and parse the datafile from the command line. There are utilities available, like [[https://github.com/CoohLand/Trout|Trout]] for Linux, that will directly read and parse the datafile from the command line.
  
-**You MUST exit untethered mode before the device times out.** Failure to do so will cause loss of data and may corrupt the FAT file system.+
  
  
  
  
t4_datalogger.1717525215.txt.gz · Last modified: by tony

Page Tools