Powering up and pairing the Twiddler via Bluetooth for the first time

To wirelessly connect your Twiddler to your device:

  1. Press the touchpad to activate the Twiddler
  2. 3 LED lights (RGB) should light up then a single Blue LED should be flashing.
  3. tgimages.s3.amazonaws.com_twiddler_wiki_pairinglights.jpg
  4. On your Host's Bluetooth device list, you should see Twiddler 4.
  5. tgimages.s3.amazonaws.com_twiddler_wiki_bluetoothsettings.jpg
  6. Select it to connect and you’re good to go!

The Twiddler is easily woken up by pressing the touchpad and it will last for months in the stand by mode.

NOTE: The Twiddler 4 does not have an on/off switch. The Twiddler 4 will automatically power down when not in use for a period of time. This timeout can be customized by changing the Idle Time until Sleep in Twiddler Tuner.

Twiddler 4 uses USB-C to charge (a USB-A to USB-C cable is not included). You can use the Twiddler and charge it at the same time when the Twiddler is connected to your device via USB.