===== Untethered Re-Chording Mode =====

//**Feature still under development**//

Untethered Re-Chording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run hostless and will record every HID code to an on-board data file. It acts as a Datalogger.

Use tuner to enable this mode and assign its functions to your preferred key chord.

When recording, the Twiddler saves the keystrokes, in HID format, in a .log file on the Twiddler.  The naming corresponds to the config file you were using at the time.  Example:  You are using 1.cfg and start Untethered Mode.  The datafile will be 1.log.  

To retrieve the recorded data: 
  - Connect to a host
  - Make sure you are using the config file you used to record the data
  - Open a notepad or word processor on your host
  - press the chord to playback the data on your host

The Twiddler will play back the data as quickly as the connection supports.

There are utilities available, like [[https://github.com/CoohLand/Trout|Trout]] for Linux, that will directly read and parse the datafile from the command line.