Differences

This shows you the differences between two versions of the page.

--- t4_datalogger [2024/06/03 20:38] – tony
+++ t4_datalogger [2024/07/09 17:31] (current) – lalaine
@@ Line 1: / Line 1: @@
-===== Untethered Re-Cording Mode =====
+===== Untethered Re-Chording Mode =====
-Untethered Re-Cording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run hostless and will record every HID code to an on-board data file. It acts as a Datalogger.
+//**Feature still under development**//
-When recording, the Twiddler saves the keystrokes in a .log file on the Twiddler.  The naming corresponds to the config file you were using at the time.  Example:  You are using 1.cfg and start Untethered Mode.  The datafile will be 1.log.
+Untethered Re-Chording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run hostless and will record every HID code to an on-board data file. It acts as a Datalogger.
+Use tuner to enable this mode and assign its functions to your preferred key chord.
+When recording, the Twiddler saves the keystrokes, in HID format, in a .log file on the Twiddler.  The naming corresponds to the config file you were using at the time.  Example:  You are using 1.cfg and start Untethered Mode.  The datafile will be 1.log.
 To retrieve the recorded data:
@@ Line 15: / Line 19: @@
 There are utilities available, like [[https://github.com/CoohLand/Trout|Trout]] for Linux, that will directly read and parse the datafile from the command line.
-**You MUST exit untethered mode before the device times out.** Failure to do so will cause loss of data and may corrupt the FAT file system.

Twiddler

User Tools

Site Tools

Differences

Page Tools