Differences

This shows you the differences between two versions of the page.

--- datalogger [2018/01/08 15:41] – tony
+++ datalogger [2024/05/03 17:21] (current) – external edit 127.0.0.1
@@ Line 1: / Line 1: @@
-=====The Data Logger=====
+===== Untethered Re-Cording Mode =====
-Untethered Re-Cording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run headless and will record every keystroke to an on board data file.  When you connect the Twiddler to a host device, you can re-play all the keystrokes to have them automatically entered into your program of choice.  There are utilities available, like [[https://github.com/CoohLand/Trout|Trout]] for Linux, that will directly read and parse the datafile from the command line.
+Untethered Re-Cording mode was introduced in [[twiddler_firmware|Version 12]] of the Twiddler Firmware.  In this mode, the Twiddler can run headless and will record every HID code to an on-board data file.  When you connect the Twiddler to a host device, you can re-play all the HID codes to have them automatically entered into your program of choice.  There are utilities available, like [[https://github.com/CoohLand/Trout|Trout]] for Linux, that will directly read and parse the datafile from the command line.
 To enter untethered mode, just type [[chordnotation|N+S 00M0]].  Everything typed from this point forward will be logged to a file on the Twiddler's [[flashdisk|Flash Disk]].  To exit untethered mode, use the same chord [[chordnotation|N+S 00M0]].  **You MUST exit untethered mode before turning the power switch off to ensure the most recently typed data is saved and the flash disk is handled gracefully.** Failure to do so will cause loss of data and may corrupt the FAT file system.

Twiddler

User Tools

Site Tools

Differences

Page Tools